PATHÉSCOPE 200B PROJECTOR
LAMP MODIFICATION
from Grahame L. Newnham
The Pathéscope 200B cine projector was sold in large quantities up to the second World War. These days they still often turn up in reasonable working order. Assuming the motor is still OK (check the brushes for excess wear) and the film gate, gears, cam and bearings etc. are not too worn, a quick clean up and lubrication gets the machine in running order.
The main problem is the projection lamp - quite advanced in it's time (mid. 1930s), generally it was a 200 watt 110 volt lamp with the special Pathéscope 'T' fitting base - type A1/81 (although models were also made with a 50 volt 250 watt lamp and 50 volt motor and also a mains voltage version with 250 watt 240 volt lamp and motor. (The 50 volt version will be more difficult to convert because of the 50 volt motor voltage). Supplies of 200B lamps dried up many moons ago and in any case the special dropper resistor normally supplied with these machines in the UK will not be too electrically safe these days.
The usual 200B lamp - 110 volt 200 watt A1/81 -
rather rare these days!
One approach to the problem is to use a more modern type of Q.I. lamp - the A1/216 rated at 24volts 150watt. These are currently still available and used in current optical devices and disco lighting. A suitable 110 volt and 24 volt power supply can be built into the original dropper resistance box using a modern toroidal transformer. The 110 volt motor supply can be connected via the original 2 pin input socket on the projector, whilst an earth and the 24 volt lamp supply can be connected via the three pin socket on the other side of the base of the projector, or via a three pin cable connector. The existing motor wiring, or replacement if the insulation is badly failing, is internally connected to the existing two pin socket, whilst new cable is used to supply the replacement lampholder.
The existing bakelite lamp holder is removed and a small piece of metal or tufnol is cut to cover the hole. The new lamp holder for the A1/216 lamp can be mounted on two stand off 4BA bolts - the exact fitting position being achieved by adjusting the fixing nuts - see photo below.
200B lamp modification
Results are excellent, a slightly brighter and whiter
picture and a bit less heat; plus replacement lamps are currently
still available and at prices below a fiver!
Osram Xenaphot A1/216 lamps are usually on my sales lists (gln Jan2018)
Return to: PATHESCOPE 200B
New: 09Jan2018 .......... Last updated: 16 Feb 2020 .......... 95gearpathe200blampmod.htm ....................... @MMXV111 Grahame L. Newnham